SER NAT Gateway
From MetaWiki
Here is my latest config file and it works. I think :)
I setup the Sip Phone with a domain that is pointing to the public ip address of the virtual IP on the Metaswitch. I put the ip address of the SER server into the proxy section of the client. In my firewall I only allow the ip address of the SER server to talk directly to the virtual IP on the Metaswitch.
My clients are registering with the Metaswitch, but have a contact address of the SER server. Change ip addresses in the file from '192.168.1.1' to whatever the public ip address is on your SER server. There are two places to change it. My goal is to eventually have it sit
- DISCLAIMER***
I am not running this in production, but it's fun to play with for now. Feel free to play too, but share you updates. :)
Related Links
To get this far I had to do a lot of term paper reading and you really can't call this a session border controller though. Because...
1. it doesn't do mgcp or any other signaling beside sip 2. it doesn't transcode codec's between clients, the rtpproxy is just a port redirector to enable two clients with one, or both, behind NAT to talk. 3. It's stateless, although right now I don't see where that is a problem.
Natambu Obleton Network Engineer FastTrack Communications
SER Config File - V0.2
want to spend a vacation with your family? treat them like you've never done before, make then experience what is a real vacation place, then you might want to try this site.
